Basically, I took the green wirewhich is connected to the Kenwood harness, twisted it together with the ground black wirealso part of the Kenwood harnessand then twisted these two wires together with the ground wire of the aftermarket Scosche wire harness used to connect the Kenwood into the truck's system.
To finish, I slid these wires into a crimp cap, pressed down with the crimper, and I was done! By doing the by-pass, the unit thinks I'm always in park. This is the only by-pass you need to do on the Kenwood. Let me know if you have any questions Kiko Tx , Feb 5, Show Ignored Content. Kenwood DMXS 6. Rockford Fosgate RX2 Prime 6. Compact Design. Backlit LCD Display. To prevent a short circuit, remove the key from the ignition and disconnect the - battery. Make the proper input and output wire connections for each unit.
Connect the speaker wires of the wiring harness. Connect the wiring harness wires in the following order: ground, battery, ignition. Connect the wiring harness connector to the unit. Always connect those wires to the power source running through the fuse box. The power supply must be connected to the wires via the fuse. This process could take up to several minutes. Make sure your vehicle is outdoors in an open area away from tall buildings and trees for fastest acquisition. After the system acquires satellites for the first time, it will acquire satellites quickly each time thereafter.
Therefore, the speaker wire should be checked. If you connect the ignition wire to a power source with a constant voltage supply, as with battery wires, the battery may die. Attached Images. One more thing. I know there was a link somewhere and I think it was on here that documents removing the interior pieces necessary to access the stereo. What I find interesting is that his '03 looks more like my ' I have the black frame around the climate controls, and the granite like finish on the little pocket.
I wonder what all that means. Jeff '04 LTD. What do you think of the metra kit, like the one this guy used it looks really nice.
Where to put the ipod connector? I didn't want to put a big hole in the bottom of the cubby under the AC controls. Yet I want it to be convenient.
So I was thinking I could cut a hole behind the cubby and just snake the wire through the top of the cubby. Any ideas? I got the wrong wiring harness which I didn't realize till everything was hooked up. So now my car is apart with no stereo and my wife needs it next week. Since getting the new harness will likely take a week it sux. I can't select the GPS system, the icon is grey'd out. Anyone know why? Also to note, you can hook up an ipod or a USB thumb drive, not both at the same time. For selecting nav, you can use v.
I just got this installed at 5 am on wednesday!! Still figuring out stuff.
0コメント